Retsch GM 200 - Manual (Page 29)

Operating the machine
29
The LED over the button lights up. The set speed is shown in the display if it is not
larger than 4000 rpm.
• Press the START button.
Grinding now takes places in the interval mode.
• To end interval grinding press the interval button (E11) once again.
The LED above the interval button goes out and the speed maintains the value of
4000 rpm. The device is in continuous mode again .
Pos : 8. 50 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Revers e - Ver mahl ung @ 3\ mod_1279717723614_9.doc @ 21493 @ @ 1
5.14 Reverse grinding
Pos : 8. 51 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ GM200 (2010)/ 0015 GM200N Bedienung/ 1580 GM 200_2010 Mo dul Revers e - Ver mahl ung @ 3\ mod_1279722273044_9.doc @ 21676 @ @ 1
• Press the REVERSE button (E10).
Fig. 11: Switching on interval operation
The LED above the REVERSE button lights up.
• Press the START button.
Grinding takes place in reverse mode and the motor runs against the cutting
direction. Grinding takes place by impact unlike normal mode (cutting).
• Press the REVERSE button (E11) to leave the reverse mode again.
The LED above the REVERSE button lights up. The device is in normal mode once
again
– grinding by cutting .
Pos : 8. 52 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Q uic k St art - T as tenf unktion @ 1\ mod_1240313233592_9.doc @ 8229 @ 2 @ 1 Pos : 8. 53 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ GM200 (2010)/ 0015 GM200N Bedienung/ 1585 GM 200_2010 Modul Q uic k St art - T ast enf unktion @ 3\ mod_1279722273888_9. doc @ 21685 @ @ 1
• Press the QUICK button (E12).
Fig. 12: QUICK grinding
The LED above the button lights up and grinding starts immediately.
• Release the QUICK button, grinding is ended immediately and the LED
above the button goes out.
Pos : 8. 54 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Speicher – F unktionen @ 3\mod_1279718043115_9.doc @ 21517 @ @ 1
E12
E10