Retsch GM 200 - Manual (Page 25)

Operating the machine
25
NOTE
The gravitation lids for the plastic jug differ from the gravitation lids for the glass
and steel grinding jugs.
Pos : 8. 37 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Füll en des Behält ers @ 2 \ mod_1267774868556_9. doc @ 18870 @ 2 @ 1
5.10 Filling the vessel
Pos : 8. 38 /00004 Warnhinweis e/ V0039 VOR SICHT Sc hnitt verletzung Scharf e M ess erkli nge ( GM200_2010) @ 3\ mod_1282898421988_9. doc @ 22916 @ @ 1
CAUTION
2.V0039
Danger of injuries caused by cuts
Sharp cutters
–
The cutters are very sharp and may lead to injuries caused by cuts if
handled incorrectly.
• Do not directly take hold of the cutters.
• Only reach into the grinding jar if it is outside the device.
• Do not reach into the grinding jar if the sample material still covers
the cutter.
• Before taking out the cutter remove as much sample material to
safely grip the cutter.
Pos : 8. 39 /00004 Warnhinweis e/H 0054 HIN WEIS Haube mus s sic her i n den Verriegelungsbolz en ei nras ten @ 3\ mod_1283176291349_9.doc @ 22962 @ @ 1
NOTE
3.H0054
The hood must safely latch into the interlock pin so that the motor can start or so
that no emergency brake is triggered during grinding.
Insert the cutter cylinder before adding the sample material because otherwise it
may fall between cutter cylinder and jug.
Pos : 8. 40 /00005 Ü berschrif ten/ 1. 1. 1 Ü bersc hrift en/ 111 F üllen – i nnerhalb des Ger ätes @ 3\mod_1279716876335_9.doc @ 21485 @ @ 1
5.10.1 Filling – within the device
Pos : 8. 41 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ GM200 (2010)/ 0015 GM200N Bedienung/ 1560 GM 200_2010 Modul Füll en inner hal b @ 3\ mod_1279721707174_9. doc @ 21631 @ @ 1
• Insert the jug.
• Position the cutter cylinder and push it down as far as it will go.
• Add the sample material.
• Put on the lid.
• Close the hood until it latches into the interlock pin (J).