Retsch AS 200 - Manual (Page 30)

31.07.2012

Retsch GmbH
30
Safety regulations for the AS200
Extract from the individual chapters
Subject Action Hazards
Vibration height Vibration height >2.5 mm in the
AS200 basic and digit models Armature strikes the magnets;
mechanical components could
be damaged.
Shipping During shipment the AS200 is not
to be subjected to impact or
vibration; do not throw the
package. Electronic and mechanical
components could be damaged.
Temperature
fluctuation In case of temperature
fluctuations, protect the AS200
against condensation.
Electronic components could be
damaged.
Scope of supply If the shipment is not complete or
is damaged, you must notify the
forwarder and Retsch GmbH
immediately (within 24 hours). Under certain circumstances
compensation cannot be paid
for claims which are lodged
later.
Ambient
temperature Temperature below 5°C
Temperature above 40°C Electronic components could be
damaged.
Humidity Exceeding 80% R.H. at
temperatures up to 31°C
Electronic components could be
damaged.
Installation Shipping nuts not removed. Mechanical and electronic
components could be damaged.
Electrical
connection Local power supply does not
correspond to the values given on
the data plate. Mechanical and electrical
components could be damaged.
Sieving aids Stretching the sieve weave due to
excessive charge weight. The precision of the analytical
sieve can be impaired.
Sieved product
distribution Use the long threaded rods when
working with only one to three
sieves. Overly long rods, extending
above the stack, will interfere
with distribution of the product
due to their intrinsic resonance.
Wet sieving Never place the AS200 directly in
a basin for operation Fatal electrical shock hazard.
Line power socket not protected
with a ground fault interrupter. Fatal electrical shock hazard.
Water volume too great. Water backing up in the sieve
stack can cause overloading
and thus may damage or
destroy the sieve weave.
Cleaning Never clean the AS200 with
running water. Fatal electrical shock hazard.