Retsch AS 400 - Manual (Page 13)

06.11.2012

Retsch GmbH 13
Installing and clamping the analytical sieves
The AS400 control is suitable for use with analytical sieves with
outer diameters of 100 / 150 / 200 / 203(8“) / 305(12“) / 315
and 400mm.
A variety of clamping units and covers are available for this pur-
pose (see the accessories listing).
With the standard sieve clamping unit
F G
H I
 Screw the threaded rods H into the sieve disk and lock with
the hex nuts I.
 Center the selected sieve stack on the sieve disk
 Lay the standard clamping cover F over the threaded rods
on the top sieve.
 Tilt the clamping nuts G to slide them over the stand thread
and down to the clamping cover and fasten securely by
hand.
We recommend the use of talcum powder if the base pan sticks
to the smooth surface of the sieve carrier when removing the
sieve stack.