Salsbury Industries 19000 Series Cell Phone Lockers Surface Mounted User Manual
Page 2
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-
5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-
5299 Int’l Fax: 323-846-6800
www.lockers.com
www.mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. (Rev. 12, 1/21/2014) Page 2 of 10
Cell Phone Lockers - 19100 Series
Surface Mounted with Front Access Panel
Installation Instructions
Installation of the Surface Mounted Enclosure
Remove the locker unit from the enclosure. Drill mounting holes in
the enclosure to fasten it to the mounting surface. It is important to
use at least four (4) fasteners (not provided) and place one each at
the four (4) corners of the mounting surface (either on the rear panel
or the bottom panel). Choose appropriate hardware for the particular
conditions of the installation.
Installing the Cell Phone Locker into the Enclosure
Install the locker unit into the enclosure by sliding it into the enclosure
until its front peripheral flange is flush against the front of the
enclosure. Open the front panel access compartment of the cell
phone locker then open the front panel. Install #8 x 3/4 in. long
screws (provided) through the slots in the sides of the front peripheral
flange of the locker unit into the enclosure. Close the front panel
then the front panel access compartment.