Salsbury Industries 19000 Series Cell Phone Lockers Surface Mounted - Manual (Page 9)

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.lockers.com www.mailboxes.com engineering @ mailboxes.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. (Rev. 12, 1/21/2014) Page 9 of 10
Cell Phone Lockers
– 19000/19100 Series
Identification Window Installation Instructions
Installation of Identification Window
Identification labels, clear plastic windows, and metal
window backup plates are provided, separately bagged,
for use in marking the user’s identity on each locker door.
The steps below are numbered according to the picture to
the right.
1. Mark the user’s name or other appropriate identity on
one of the ½” x 2” labels provided. Tear the label from
the card.
2. Insert the label into the clear plastic window so that the
marking will be visible from the front of the locker door.
3. Place the clear plastic window into the rectangular hole
in the door so that the identity is visible from the front of
the door.
4. Slide metal window backup plate down into grooves at
top of door. Slide plate down until it covers the plastic
window and the bent lip of the plate rests on the top edge
of the plastic window.
2
3
4
1
REAR VIEW