Schwank Parasol Series Portable - Manual (Page 5)

4002/5-CB I&O Manual
IM080811
RD: NOV 2013
R.L. 02B
BA
3.1 GAS REQUIREMENTS AND LEAK TESTING:
NEVER CONNECT AN UNREGULATED GAS SUPPLY TO THE HEATER.
The propane connection hose supplied with the heater has a pressure regulator integrated
into the hose .
PRECAUTIONS:
 Periodically check the whole system for leaks or if the smell of gas is detected.
 Extinguish all open flames.

Perform ALL leak testing outdoors.
 Never smoke while leak testing.
 Only parts recommended and supplied by the Manufacturer should be used for repair. Substitution
could result in improper repair and cause fire, property damage, personal injury or death. Improper
repair will also void the warranty.
 Do not use the heater until all connections have been leak tested and are sound !!!
LEAK TESTING:
1. Ensure that the heater gas control knob is fully closed by turning completely clockwise.
2. Open cylinder valve for Propane supply .
3. Apply the soap solution generously to all connections and hoses.
4. Carefully examine all connections in the gas train.
5. If bubbles occur, there IS a leak. Close supply valve completely.
6. Retighten the leaking connection and repeat leak test process, until ALL leaking has ceased, no
matter how small the bubbles may appear.
If the leak cannot be repaired permanently, close the cylinder valve completely and contact a
qualified and licensed gas technician for repair parts and service.
GAS REQUIREMENTS:
 Maximum inlet pressure to propane regulator must not exceed 1/2 psi (14” w.c.).
 A Minimum supply pressure of 11.0” w.c. is required to maintain correct burner input.
 The pressure regulator and hose assembly supplied with the appliance MUST be used. Any
replacement pressure regulator and hose must conform to standards & specifications of
all national and local codes.
 Installation must conform with all national and local codes.
Page 2