Schwank STSp-CANADA - Manual (Page 16)

SP-MSTP-AC-15A
STS-p Manual
RD: DEC, 2003
RL:15
KH
Page 12
10. FOCUS SHIELD REFLECTOR INSTALLATION
After burner and tubes have been installed,
slide the focus shield reflectors one at a time
into the wire hangers, (the end of the first and
last focus shield reflectors must be secured to
the first and last end plate hangers with four
screws each. SEE FIGURE 13 (ABOVE) and
FIGURE 12 (PAGE 11). As each successive
focus shield reflector is installed on an in-line
installation, the ends of the focus shield
reflectors will meet at the centre of the reflec-
tor slide to provide continuous coverage over
the entire tube system.
Reflector slides are provided to support and
attach one focus shield reflector to another.
Slide focus shield reflector (1) over reflector
slide (2), fit focus shield reflector standing
edge (3) into reflector slide lip (4).
*Note: Each heater comes with one 9'5''
reflector; the balance of reflectors for each
heater are 9' 8” long. The 9'5'' reflector can
be mounted in any location. Focus shield reflectors should touch at
centre of reflector slide. SEE FIGURE 14
(PAGE 13). Reflectors must BE FREE to
slide due to expansion. Do NOT hard
fasten.
NOTE: DO NOT SCREW FOCUS
SHIELD REFLECTORS AND SLIDE
TOGETHER.
Each focus shield reflector section can be
individually adjusted to either side, up to
45
O from horizontal, by orienting the
hangers appropriately. SEE FIGURE 15
(PAGE 13), FIGURE 16 (PAGE 14) Note
that for both horizontal and angle mounting,
the tube must be level. Improper mounting
can result in overheating of controls and
combustible materials. Use only
non-combustible mounting hardware.
FIGURE 13 MOUNTING FOCUS SHIELD REFLECTOR TO END PLATE HANGER
1 End-Plate-Hanger Flange over
the Reflector
2 End-Plate-Hanger Flange under
the Reflector
3 Screws securing Reflector to
End-Plate-Hanger
4 Chain Hole for horizontal
suspension
5 Chain Hole for up to 45º
suspension
6 Opening for Tube
7 Focus-Shield Reflector*
6
5
4
7
3
1
2
1
7