Schwank SCH-200 Construction - Manual (Page 6)

SP-MCH2-BX-07A
SCH-200 MANUAL
R.D: Sept 2004
RL: 7
KH
WARNING
•
DO NOT use heater in living or office areas.
•
Approved for heating buildings or structures
under construction, alteration or repair.
•
Use only in well ventilated areas.
•
Heater must be used exclusively for heating
purposes.
•
The distance between the heating surface top to
the nearest combustible must be at least 48
inches. The distance from the burner surface, in
a horizontal plane, to the nearest combustible
must be at least 52 inches.
•
The heater must not be directed towards any LP
gas container within 15 feet.
•
The fuel supply line must not be placed near the
burner heat zone.
•
DO NOT store or use gasoline or other
flammable vapors or liquids in the vicinity of this
or any other appliance.
•
DO NOT use this heater if any part has been
under water. Call a professional gas appliance
service person to inspect the heater, and to
replace any part which has been under water.
•
Any changes to this heater or the heater’s
controls can be very dangerous.
•
Any part removed must be replaced prior to
operating the heater.
•
Failure to follow these warnings may result in
property damage, bodily injury or death.
•
The heater must be installed in such a way that it
is not directly exposed to water spray, rain and or
dripping water.
HEATER
MUST BE
LEVEL
BEFORE
OPERATING
NOT FOR HOME OR
RECREATIONAL VEHICLE USE
This heater is designed and approved for use as
a construction heater per Canadian Standard
2.14 and Ansi Z83.7-2000.
CHECK WITH YOUR LOCAL FIRE SAFETY
AUTHORITY IF YOU HAVE ANY QUESTIONS
ABOUT APPLICATIONS.
Other standards govern the use of fuel gases and
heat producing products in specific applications.
Your local authority can advise you about these.
WARNING WARNING
Page 2