Sensaphone Express II - Manual (Page 48)

46
Sensaphone ® Express II User’s Manual
OUTPUTS [8]
Up to 16 outputs may be installed in Express II.
1. Manual—This type of output is turned on/off
manually by the user. It is available only if you
purchased an output card for the Express II. These
cards look no different than the Input cards you can
add and are installed the same way.
2. Auto-any alarm—Output #0, which comes built
into the unit, can be switched on automatically when
alarm recognition occurs, and off again when the
alarm is acknowledged. The condition causing the
alarm may still exist, but the auto-alarm will be off.
(See Figure 11 for location of this Output Relay.)
Outputs may be useful if you want to have equipment
hooked up to the Express II. For instance, if the
unit is monitoring temperature in a particular
environment, you might have a fan or heater hooked
up to an output, which you could switch on over
the phone if the temperature exceeded prescribed
parameters.
See Chapter Four for more information on Outputs.
OUTPUT PARAMETERS
1) Press Program.
2) Press Output.
3) Enter output number (0-16).
4) Press 1 for manual.
Press 1 for OFF.
Press 2 for ON.
5) Press 2 for automatic-any alarm. Only
for output # 0.