Sensaphone 800 - Manual (Page 108)

Sensaphone
®
Model 800 User’s Manual
106
8 .2 Switching The Output Using The Keypad
When programmed for Manual mode, the command to switch the
output is:
SENSOR ON/OFF + OUTPUT.
SENSOR
ON/OFF
OUTPUT
PAUSE
AM
The 800 will respond “The output is on/off” to indicate the state
of the output.
Note: If the 800 says “Error,” the output is not programmed for
manual mode.
8 .2 .1 Switching the Output Over the Phone
The following commands will allow you to check the status of the
relay output and to toggle the Relay Output On and Off.
To recite the Output Status press W(9) + R(7) + O(6)
To switch the Output press S(7) + R(7) + O(6)
8 .3 Typical Applications
Heating Up Your Cottage Or Cabin Remotely
If you keep your cottage or cabin open all year around, or if you
do not drain your pipes and add antifreeze to your plumbing, you
likely keep your furnace active when you are away but at a very
low temperature. The Sensaphone will provide an invaluable
service to you by keeping you updated to any change in the status
of your furnace operation. Prior to your arrival at your cottage
or cabin, you can remotely use your Sensaphone 800 to raise the
thermostat and increase the heat.
Most furnaces use a typical 4-wire (heat/cooling) or 3-wire (heat
only) thermostat. The Sensaphone can easily control these types
of thermostats. If your heating source consists of high voltage
electric baseboard heaters, you should consult a qualified
9
wxyz
7
pqrs
6
mno
7
pqrs
7
pqrs
6
mno