SPYPOINT S-HD-12 User Manual
Page 6
10
11
English
English
VIDEO
Press "OK" to select "VIDEO" ; the test light in
the front of the camera will flash for 60 seconds to
allow the operator to walk away from the camera
without being recorded.
TEST
To set the camera and the desired distance, select
"TEST" mode. No picture or video will be recorded.
Walk in front of the camera. When the camera
detects movement, the light flashes to indicate that normally,
a photo or video would have been recorded. If the system does
not detect the movement, increase the distance detection using
the dial "DISTANCE" or realign the system differently. Once
you understand how the device responds to detections, you can
better adjust the direction or the height of the camera.
In
"
Test
"
mode, it is possible to take a picture by pressing
the
"
OK
"
button. The photo is saved and appears in the
"
View
"
mode.
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
Video
T
Test
Test light
SETTINGS
Allows the operator's own settings. To set the
system in English, hold the button "" until
"Language" is highlighted. Press "OK", select
"English" with the button "" or "" and confirm your choice
with "OK". The system will than change the menus to English.
Time Start /
Time Stop:
Allow the user to set the period of operation
of the camera. The start and stop times are
the hours during the camera is in action
and records pictures or videos. Example:
If the user selects "7:00 am" start time and
"11:00 am" stop time, the camera will only
detect for that period of time and will stay
inactive for the remaining hours. Press "OK"
and use "" or "" to adjust the hours. Press
again "OK" to set the minutes. When the time
is properly set, press "OK".
For an activation of 24 hours, the same start
and stop times must be entered (example:
00:00 as start time and 00:00 as stop time.
These hours are the basic settings of your
camera)
Note: The
hours are recorded over a 24-hour
period. For example, 5pm is 17:00 (00:00
means midnight).
Delay:
(10s/30s/1m/5m/
15m/30m)
Select the time interval between photos or
videos.
Note: A shorter detection delay results in a
shorter battery life.
Multi-shot:
(1/2/3/4/5/6
consecutive shots)
Take up to 6 consecutive shots for each
detection, with a 10-second delay between
each photo. This option allows up to 6 pictures
from different angles when the camera is in
"PHOTO" mode.
Settings