SPYPOINT S-LIVE-3G - Manual (Page 6)

10 11
English
English
MAIN MENU
Use the ▲ and ▼ button to navigate the interface or to modify a
selection, the OK button to select and the BACK button to return to
the previous menu.
The following information appears on the main menu screen:
1.Serial number
2.Software version
PHOTO
Allows the camera to take pictures in Standalone, Cellular
or Security mode (see SETTINGS MENU for details).
Standalone: When PHOTO mode is selected, the test light in front
of the camera flashes for 60 seconds to allow the user to leave the
area without being photographed. A countdown is also displayed on
the screen during boot time.
1. 2.
Test light
Cellular/Security: When PHOTO mode is selected, the camera
connects to the mySPYPOINT ™ service and displays the connection
status on the screen. The test light on the front of the camera flashes
for 60 seconds to allow the user to leave the area without being
photographed. A countdown is also displayed on the screen during
boot time.
Note: If communication is not established, the PHOTO mode is
defused and an appropriate error message is displayed on the screen.
(See ERROR MESSAGE section for details)
VIDEO
Allows the camera to record movies in Standalone mode
only.
(see SETTINGS MENU for details).
Standalone: When VIDEO mode is selected, the test light in front
of the camera flashes for 60 seconds to allow the user to leave
without being recorded. A countdown is also displayed on the
screen during boot time.
Cellular/Security: If the camera is set to Cellular or Security
mode, a message indicates that the camera will be transferred in
Standalone mode and then boots up normally.
SETTINGS
Sets the advanced options of the camera
(see SETTINGS MENU for details).
TEST
Allows the user to test the detection system of the camera.
When the TEST mode is selected, no photo or video is
recorded. Pass in front of the camera from left to right. When the
camera detects motion, the test light blinks to indicate that the
camera would normally have saved a photo or video. If the system
does not detect movement, increase the detection range using the
option «Sensitivity» in the Settings menu ( «Low», «Medium» or
«High»). Realign the system if necessary.