SPYPOINT TINY - Manual (Page 19)

36 37
English
English
1. ALK / RECH (switch for battery)
2. SD card slot
3. USB port
4. 12 volts jack
5. External trigger jack
6. TV OUT
7. Removable battery case
1.
4. 3.
5.
7.
2.
6.
POWER
The battery level is shown in the «Report» mode.
(4/4 = full, 1/4= low) When the battery level shows 2/4,
the camera will continue to take pictures but we strongly
recommend changing the batteries before they are empty.
Alkaline batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline batteries is strongly recommended. Also note
that the voltage of rechargeable AA batteries (1.2V) is
insufficient to power your SPYPOINT camera. During the
installation of alkaline batteries, place the switch inside the
battery case to “ALK” (i.e. alkaline). Insert the batteries in
the battery case as indicated and insert it inside the camera
(see figure below). Exact polarity must be followed. We also
recommend the use of new batteries to ensure maximum
performance of your camera (see figure below)
Connector Connector
Top