SPYPOINT TINY - Manual (Page 24)

46 47
English
English
Side Sensors: When the side sensors are activated, a total of
7 zones is covered. The central sensor covers
5 zones. The side detectors are mainly used
to prepare the camera so when your target
passes through the central sensor, the system
is already pre triggered, increasing greatly
the reaction time of your camera.
Note: The “Time Lapse” mode only applies
in “PHOTO” mode, not in “VIDEO” mode.
When “Time Lapse” mode is selected, the
“Delay” mode and the “Multi-shot” mode
are disabled.
REPORT
The report mode keeps a record of the last period of use of
the camera. The beginning date corresponds with the moment
the camera is set to either “Photo” or “Video” mode. Thus,
the report is reset when changing modes.
1.
2.
3.
4.
5.
6.
7.
8.
9.
1. Beginning and end date of the report
2. Number of photos or videos taken during the day
3. Number of photos or videos taken at night
4. Total of photos or videos taken
5. Current time of the camera
6. Current date of the camera
7. Battery level (1/4 = low, 4/4 = full)
8. Remaining space on the SD card estimated by a number
of photos
9. Used space on the SD card (total number of files, only
includes photos and videos taken by a SPYPOINT camera)
Note: The side sensors require more battery
power.
Time Lapse: Allow the user to set the frequency at which time
the camera takes a picture, without detection.
For example, if the option “5 minutes” is
selected in the “Time Lapse” mode, the camera
takes a picture every 5 minutes during that
period of operation (time start and time stop)
even if there is no detection.
This option allows the user to obtain
pictures of game outside the detection range
of the camera.
26’
(8m)
30’
(9m)
50’
(15m)
30° 70° 40°
6
&
6
Camera
s: side sensors
c: central sensor
Detection distance
(central)
Detection angles
Viewing angle
Detection distance
of the side sensors