SPYPOINT TINY - Manual (Page 20)

38 39
English
English
Lithium battery pack with charger
The camera SPYPOINT TINY can be powered by a
rechargeable lithium battery LIT-C-8 (sold separately, refer
to the section “OPTIONS”). This type of battery is less
affected by cold temperatures and lasts up to 3 times more
than an alkaline battery. During the installation of lithium
battery, place the switch inside the battery case to “ALK”
(i.e. alkaline). Insert the battery in the case as indicated and
insert it inside the camera (see figure below)
12 volts Power
The camera SPYPOINT TINY can also be powered from an
external 12 volts DC input. When using a 12 volt connection,
we recommend you to remove the alkaline batteries to prevent
surcharges. During the installation of 12 volt battery, place
the switch inside the battery case to “ALK” (i.e. alkaline).
If combined with a lithium battery pack, slide the switch
to “RECH” (i.e. rechargeable). To find the accessories
available for the 12 volts, refer to the section “OPTIONS”.
P INT SPY
TM
INT P SPY
Connector Connector
Top
Solar panel
This model also offers the possibility of a connection to
a solar panel SP-12V (sold separately, refer to the section
“OPTIONS”) to maintain the charge of the lithium
battery (sold separately, refer to the section “OPTIONS”)
or the 12 volt battery (sold separately, refer to the section
“OPTIONS”). During the installation of the rechargeable
lithium battery or 12 volt battery, slide the switch inside the
battery case to “RECH” (i.e. rechargeable) to activate the
charging system of the solar panel.
Electricity
The electrical power is recommended for security purposes.
It provides an instant trigger time when a movement is
detected. We recommend to remove the alkaline batteries
when this power is used. Although lithium battery can remain
safely inside the camera and it is ideal in case of a blackout. A
12 volts DC adapter that can provide a minimum of 800 mA
will be needed (Refer to the section “OPTIONS”)
Note: when using the electricity power, the “Multi-shot”
mode and the “Delay” between photos are disabled as the
camera starts instantly every time it detects motion. Also, the
imprinting temperature on each picture is disabled.