SPYPOINT TINY-W - Manual (Page 23)

42 43
English
English
Lithium battery pack with charger
The camera can be powered by a rechargeable lithium battery
LIT-C-8 (sold separately, refer to the section “OPTIONS”).
This type of battery is less affected by cold temperatures
and lasts up to 3 times more than an alkaline battery. During
the installation of lithium battery, place the switch inside
the battery case to “ALK” (i.e. alkaline). Insert the battery
in the case as indicated and insert it inside the camera
(see figure below)
12 volts Power
The camera can also be powered from an external 12 volts
DC input. When using a 12 volt connection, we recommend
you to remove the alkaline batteries to prevent surcharges.
During the installation of 12 volt battery, place the switch
inside the battery case to “ALK” (i.e. alkaline). If combined
with a lithium battery pack, slide the switch to “RECH” (i.e.
rechargeable). To find the accessories available for the 12
volts, refer to the section “OPTIONS”.
P INT SPY
TM
INT P SPY
Connector Connector
Top
Solar panel
This model also offers the possibility of a connection to
a solar panel SP-12V (sold separately, refer to the section
“OPTIONS”) to maintain the charge of the lithium
battery (sold separately, refer to the section “OPTIONS”)
or the 12 volt battery (sold separately, refer to the section
“OPTIONS”). During the installation of the rechargeable
lithium battery or 12 volt battery, slide the switch inside the
battery case to “RECH” (i.e. rechargeable) to activate the
charging system of the solar panel.
Electricity
The electrical power is recommended for security purposes.
It provides an instant trigger time when a movement is
detected. We recommend to remove the alkaline batteries
when this power is used. Although lithium battery can remain
safely inside the camera and it is ideal in case of a blackout. A
12 volts DC adapter that can provide a minimum of 800 mA
will be needed (Refer to the section “OPTIONS”)
Note: when using the electricity power, the “Multi-shot”
mode and the “Delay” between photos are disabled as the
camera starts instantly every time it detects motion. Also, the
imprinting temperature on each picture is disabled.