SPYPOINT TINY-W - Manual (Page 25)

46 47
English
English
the receiver must be turned off. Failing to do so may cause
loss of pictures or damage the pictures already recorded on
the memory card. When the SD card is full in the camera,
the viewing screen indicates “Disk full” when “Photo”,
“Video” or “Test” mode are selected. When the SD card is
full in the receiver, the transmission and recording of images
continues by clearing the first photos on the memory card.
The following data shows an approximate quantity of photos
or video length that can be taken by the camera depending on
the memory card capacity.
RESOLUTION 2.0 GB 4.0 GB 8.0 GB 32 GB
5 MP
6 MP
8 MP
10 MP
12 MP
1190
952
635
595
476
2380
1904
1270
1190
952
4760
3808
2540
2380
1904
19040
15232
10160
9520
7616
VIDEO RESOLUTION
320 x 240
640 x 480
45 min
30 min
1h30
1h
3h
2h
12h
8h
If the memory card is locked in the camera, the screen will
indicate “Card protect” when “Photo”, “Video” or “Test”
mode are selected. If the memory card is locked in the
receiver, the system bypasses the blockage and continues
to record photos.
PROGRAMMING
Turn on the camera to navigate in the interface by pressing
“” or “” and press “OK” for selection. To modify the
selection, press “” and “” again and press “OK” to
confirm. To return to the previous menu press “”.
PHOTO
To take pictures. The “Photo” mode must be selected by
pressing “OK”; the test light in the front of the camera will
wink for 60 seconds to allow the operator to walk away from
the camera.
VIDEO
To take videos. The “Video” mode must be selected by
pressing “OK”; the test light in the front of the camera will
wink for 60 seconds to allow the operator to walk away from
the camera.
TEST
To set the camera or the distance. When “Test” mode is
selected, no picture or video is recorded. Walk perpendicularly
in front of the camera. When the camera detects movement,
the light winks to indicate that normally, a photo or video
would have been recorded. If the system does not detect
the movement, increase the distance detection using the
“Settings” menu (the option “Sensitivity” allows the user
to set the sensitivity to “High”, “Medium” or “Low”). You
can also realign the camera differently. Once you understand
how the device responds to detections, you can better adjust
the direction or the height of the camera (Recommended
installation height: less than 5 feet).