Getting started – SPYPOINT XCEL HD2 User Manual User Manual
Page 6
6
Getting started
INSERTING THE MICROSD CARD
Insert a microSD memory card in the card slot, gold
contacts facing up. The card is inserted correctly when
a click is heard.
REMOVING THE MICROSD CARD
Lightly press the memory card into the camera once to pop it out of the slot
and remove it.
BATTERY INSTALLATION
Unlock the battery compartment cover by moving the lock
button to the right and remove the cover.
Insert the lithium-ion polymer battery (included) into
the battery compartment.
TURNING ON THE CAMERA
To turn on the camera, press and hold the button a few seconds
until the welcome screen appears.
To turn off the camera, press and hold the button a few seconds
until the shutdown screen appears.
BUTTON FUNCTION
1. : ON-OFF/ START-STOP
2. M: Changes mode/ Next
3. OK: Confirm entries/ Zoom (+)*
4. BACK: Exit the menu/ Previous/ Zoom (-)*
*XCEL HD2 only
USING THE CAMERA WITH THE WATERPROOF HOUSING
(XHD-OHT or XHD-OHC)
Insert the camera into the housing and close it tightly. The
housing can then be installed on any mount compatible
with XCEL action cameras. It protects the camera and
allows to use for underwater use. The housing is waterproof
up to 160 ft. (image: camera with XHD-OHT housing)
An access screw for the microphone is located at the
back of the housing. Remove the screw completely to
improve sound recording. Note that the housing is no longer
waterproof if the screw is loosened or removed, the water
will infiltrate into the housing.
USING THE CAMERA WITHOUT THE WATERPROOF HOUSING
To use the camera without the housing, it is necessary to
use the slide adaptor. This allows you to attach the camera
on any mount compatible with XCEL action cameras. Install
the slide adaptor by sliding it in the anchorage system
located under the camera.
To remove the slide adaptor from the camera, press the
ends and slide the adaptor toward the back of the camera.
Note: The camera is compatible with microSD memory cards with
capacity up to 32 GB, class 4 or higher (not included). See AVAILABLE
Note: The battery included with the camera is partially charged. It is
possible to use the camera as is, but for best results, recharge the
battery (see CHARGING THE BATTERY section p.17).
v1.0
Note: The slide adaptor has been designed to attach securely and
adequately to the anchorage system of the camera and resist to activities
with impact.
SHUTTING
DOWN
1
2
4
3