Stack-On GC-8-RTA 4327-0707 - Manual (Page 3)

4327-0707
3 18
6. Assemble the lock and ring through the front of
the door.
Secure the lock with the locking washer and nut.
(See figure 6)
7. Before assembling the lock bars remove the key
from the lock.
To assemble the 3 point locking bar, first position the center
plate horizontally with the indented formation in the one end
pointing to the outside of the door. (See figure 7)
Slide the lock bars through the slots in the top and bottom
door brackets.
Position the square hole in the center plate over the lock
while the center plate is still in the horizontal position.
Secure the center plate to the lock with the nut.
Insert the key into the lock and try the locking mechanism.
Lubricate the tips of the lock bars if necessary.
Please note that the key only comes out of the lock only
when it is in the locked position.
8. To install the barrel rests to the cabinet, first remove the
backing from the foam rests. For help in doing this, pinch the
end of the foam to help secure the adhesive to the foam.
Attach the barrel rests to the inner sides of the cabinet at the
height shown. (See figure 8)
Place the bottom pad into the cabinet.
Figure 8
36"
STA
CK-
ON
Barrel rests
Bottom pad
Top door
bracket
Lock bar
Nut
Center plate
formed end
Bottom door
bracket
Figure 7
STA
CK-
ON
Nut
Locking
washer Ring
Lock
Figure 6
Door