Stack-On GC-8-RTA 4327-0707 - Manual (Page 4)

4327-0707
4 18
SELECTING A LOCATION
Your Security Cabinet should be installed in an isolated, dry and
secure area.
For greater security the cabinet must be fastened to a solid surface
with a minimum space on either side. Ideally the cabinet would be
installed on the side wall of a closet. (See figure 9)
The cabinet should be flat against the wall and floor. Remove the
baseboard if necessary. (See figure 10)
FLOOR MOUNT OPTION
The (4) mounting holes in the rear of the cabinet must line up with the 16"
centers of the wall studs. Drill new holes if necessary. (See figure 9)
Drill (2) 3/16" pilot holes into the wall studs lining up with the top (2)
mounting holes in the back of the cabinet. Secure the cabinet to the wall
using (2) lag bolts and washers.
Drill (2) pilot holes and secure the cabinet bottom to the floor with (2) lag
bolts and washers.
WALL MOUNT OPTION
The (4) mounting holes in the rear of the cabinet must line up with the
16" centers of the wall studs. Drill new holes in the cabinet if
necessary. (See figure 9)
Drill (4) 3/16" pilot holes into the wall studs and secure the cabinet to
the wall using (4 ea.) lag bolts and washers. (See figure 10)
Figure 9
16"
CENTERS
CABINET
TOP VIEW
MINIMUM
Figure 10
STACK-ON PRODUCTS COMPANY
P. O. BOX 489
WAUCONDA, IL 60084
IMPORTANT
Keep keys away from children. Keep this record of your serial and key
numbers in a secure place separate from your security cabinet. If you lose
your keys you will need this information as a reference for obtaining new keys.
To order a replacement key set, follow the instructions on the attached form.