Summit FF1935PL - Manual (Page 32)

32
frequently asked questions and operating guide
Problem Probable Cause What to Do
When filling the
cylinder, water
spills out when
the door is open
or close.
Cooler or freezer
door is difficult
to open
Express Chill
Zone hasn’t
cooled the
drinks and/or
foods
Functions display
won’t activate
Express Chill Zone’s
Alarm Function
won’t stop
sounding
Express Chill
Zone, Turbo Cool,
and/or Alarm
won’t activate
Refrigerator
isn’t working
* Check the energy supply.
* Make sure that the plug is properly connected to
the socket.
* Check the mains fuse.
Call an authorised service centre.
Connect the plug.
Plug another device into the socket to check it,
and change the plug if necessary.
The lid of the Express Chill
Zone is open.
Lock Function is activated.
Damaged supply cable.
Disconnected plug.
Defective plug socket.
Power Fault.
Low voltage (this can be noticed
by the bulb lights flickering in
the house).
You are trying to activate
a function while another is
already activated.
You have removed the drink or
food from the Express Chill Zone
but you haven’t deactivated the
function to turn off the alarm.
An inadequate cooling time
has been selected, with too
big a load of goods to
be chilled.
A vacuum is created when you
close and try to re-open the
cooler and freezer doors in
too quick succession.
Install an automatic voltage regulator with a
minimum power of 500 Watts and a minimum
current of 10 Amps.
Deactivate the activated function, and then
select the one you wish.
Press the Express Chill Zone Function to stop
the alarm sounding.
Deactivate the Lock Function to be able to
activate the functions display.
Cooling times vary in accordance with the size
of the load of drinks or foods, and their initial
temperature. As a result, it is recommended that you
select the same time again or an option of even
more time, and leave until your items have the
desired temperature reached.
Close the lid of the Express Chill Zone and
reprogramme the time.
1.- Wait a few minutes for the vacuum
pressure to dissipate (don’t try to open it
immediately).
2.- Open the freezer door first, and then the
cooler door.
It is possible that the seal tank has not been
located in the correct position.
The water tank is
overflowing.
Do not fill the container to the top.
The maximum water level is marked on the
cylinder.
The water from
the water
dispenser
tastes unusual.
The dispenser has not been
filled by pure drinking water.
The dispenser must be filled by pure
drinking water.
The dispenser has not been
filled cleaned.
Clean the tank for the first time of use, and
it is recommendable to clean it every 30 days.
The water tank has been
cleaned with detergents and
odorous cleaning products.
There is spillage in the
water tank.
Don’t use detergents or odorous cleaning
products.
The water dispenser is not
used regularly.
If you don’t use your water tank frecuently
throw the water, and clean the system.