Summit FF1935PL - Manual (Page 7)

7
levelling
To level the refrigerator use
the two levelling screws
found on the base at the
front. Make sure that the
refrigerator is placed on level
ground. Adjust the levelling
screws to ensure that the
refrigerator doesn’t move
during day-to-day use.
Turn the screws anti-
clockwise to lift the front of
the refrigerator and clockwise
to lower it.
The front part of the
refrigerator should be a little
higher than the back causing
it to tilt backwards slightly.
Levelling requires two people;
one to tilt the unit backwards
and the other to turn the screws.
To level it, lift the front by turning the screws until there is a 48 mm (1.9
in) gap between the floor and the base of the refrigerator, as indicated in
the figure on the right.
observe the following when installing:
important – after leaving the refrigerator to stand 6 to 8 hours
and before plugging it in:
1. Clean the interior of your refrigerator with a cloth or soft sponge, and
a neutral soap or a soda bicarbonate solution.
2. Plug it in to the correct outlet.
3. Leave it on, empty and closed, for 4 hours before putting food inside.
4. Avoid opening the door before optimum temperature has been
reached.
5. If you want to move your refrigerator to another location, disconnect
it. When it has been repositioned repeat steps 3 and 4.
caution
In the case of physical, mental or sensorial difficulties (including
children), or if you don’t have sufficient experience or knowledge to
handle this product, you will need the assistance of a capable adult
to ensure safety.
Children should always be supervised. This product is not a toy.
Levelling
screws
Front
wheels
Back
wheels
m
m8
4
Front
Front
Front
Levelling
screws
Front
wheels
Back
wheels