Summit FF1274 - Manual (Page 9)

Reinstallation:
(See Figs. #4 and #5)
1. Remove the lower pivot pin from the bracket of the lower hinge by turning
counter-clockwise. Move the pin to the opposite hole and tighten.
2. Loosen the screws holding the lower hinge bracket and remove the hinge.
3. Align the holes in the lower hinge bracket to the corresponding holes in the
opposite side of the cabinet. Insert and tighten the screws.
4. To install refrigerator door, make the left bottom hole of the refrigerator
compartment door fall over the lower hinge axle, move the door forward to
make it straight and in alignment with the central hinge. Install the central
hinge again turn the hinge axle until it completely enters the door body, then
attach it with screws.
5. To install freezer door, make the left bottom hole of freezer door fall over the
central hinge axle; raise upper hinge so that hinge axle can be installed in the
upper hole of the upper part of the freezer door; adjust door to make it straight
and level.
6. As shown in Fig. #1, install the upper freezer hinge to the left corresponding
position. (Tighten the screws of the upper hinge.)
7. Replace the hinge cover as shown in Fig. #1.
8