Summit PRO24G User Manual
Page 20
2. Unscrew the 2 screws (2) of the
injector holder (1).
3. Pull out the injector holder.
1 Injector holder
2 Screw
4. Unscrew injector by turning in
counter-clockwise direction.
5. Fit new injector.
Reduced flow adjustment for the
gas oven
For the appropriate functioning of the
oven, re-checking the bypass
adjustment is extremely important. In
order to provide maximum security to
the user, these operations have to be
performed with care.
1. Ignite the burner that is to be adjusted
and turn the knob to the high flame
position.
2. Close the oven door and wait for 10
to 15 minutes until the oven becomes
ready for adjustment.
3. Take out the knob.
4. After 15 minutes, adjust the oven to
the lowest flame position.
5. Set the flame length to about 1/10
inch (2 to 3 mm) by means of the
screw (1) on the oven tap. Turning
the screw clockwise reduces the
flame, while turning it counter-
clockwise increases the flame.
CAUTION:
If the temperature of the oven
increases more than intended, turn
off the oven and call the authorized
service center to have the oven
thermostat repaired.
19