Summit PRO24G - Manual (Page 30)

4. While placing pan supports, take care
that burners are centered on pan
supports.
Cleaning the control panel
Damage to the control panel!
Do not remove the control knobs for
control panel cleaning.
Clean control panel and control knobs.
Cleaning the oven
No oven cleaner or any other special
cleaning agent is required for cleaning
the oven. It is recommended to wipe
the oven with a damp cloth while it is still
warm.
Do not allow fat or oils to build up on the
oven base or oven accessories.
To clean the side walls,
1. Remove the front section of the side
rack by pulling it away from the side
wall.
2. Remove the side rack completely by
pulling it toward you.
Replacing the oven lamp
DANGER:
Hot surfaces may cause burns!
Make sure the appliance is switched off
and cooled down in order to avoid the
risk of an electrical shock.
The lenses must be in place when using
the oven. They protect the light bulbs
from breaking.
The lenses are made of glass. Handle
carefully to avoid breakage. Broken
glass could cause an injury.
NOTICE: Position of lamp might
vary from diagram.
Each oven is equipped with two halogen
lights located on the back wall of the
oven. The lights are switched on when
the door is opened or when the oven is
in a cooking cycle. Each light assembly
consists of a removable lens, a light
bulb and a light socket housing that is
fixed in place. Light bulb replacement is
considered to be a routine maintenance
item.
To replace a light bulb:
1. Read warning above. Be sure oven
interior is cool.
2. Turn off power at main power supply
(your fuse or circuit breaker box).
3. Remove lens, carefully pull out old
bulb and replace with a fresh one.
4. Replace lens and reconnect power.
29