Regency Horizon HZ54EPV Large Gas Fireplace - Manual (Page 33)

Regency Horizon HZ54EPV Gas Fireplace
33
INSTALLATION
RECEIVER WALL SWITCH
(Included with Unit)
1) Run the supplied 10' of the wire harness through the right or left side gas
inlet opening- connect the ON/OFF wire harness. Be careful not to damage
wire.
2) Connect the wire to the receiver wall switch and install into the low voltage
receptacle box.
Optional
REMOTE CONTROL
Use the Regency ® Remote Control approved for this unit. Use of other systems
may void your warranty.
The remote control comes with a hand held transmitter, a receiver and a wall
mounting plate.
1) Choose a convenient location on the wall to install the receiver and the
receptacle box (protection from extreme heat is very important). Run wires
from the fi replace to that location. Use Thermostat Wire Table.
CAUTION
Do not wire millivolt
wall thermostat wires
to 120V wire.
CAUTION
Do not wire millivolt
wall thermostat wires
to 120V wire.