Unisteer 8012380-01 Chevrolet C10 1973-87 - Manual (Page 6)

Page 6 657410
Installation
1. The new steering system bracket straddles the outside of the frame rails. The bolt holes line up with
the original gearbox and idler arm mount holes. The Metal Ear (#15) fits between the frame and the
Bracket on the passenger side of the frame. Once this is all tightened up you can move to the
steering shafts. Use the original tie rod ends with the new rack and pinion.
2. To install the shaft support bracket, the bolt closest to the front of the car and connected to the motor
mount has to be removed. Take the support bracket and hold it in location to mark the second hole.
Make sure this is in line with the frame. The location that is marked will have to be drilled to supply a
3/8 bolt. Once drilled apply the bracket into location. Under the front of the bracket use a 3/8 flat
washer and on the back use the 3/8 tall spacer. Using the spacers and lock nuts tighten the bolts.