USG One-Directional Curvatura 3-D System - Manual (Page 10)

Page 10 of 12
Remove any visible temporary bracing that
may have been installed. Follow the ribbon diagram to locate
the proper positions for each edge trim
segment.
…and apply fascia splices and corner
clips along the perimeter. Hook them over the bottom edge of the
trim and bend the tabs over the top as
shown here.
Remember, it’s easiest to install fascia
splices progressively. Squeeze the bottom to get a snug fit
around the trim as shown here. Then, bend the top of the splice as
shown here.
A. B.
Start the installation with an appropriate
flush-cut edge trim segment…
C. D. E.
F. G. H.
Step 5: Install Edge Trim
One-Directional C
urvatura
Installation Instructions
Remember…
For ease of installation, edge trim segments
are 1/8 shorter than main tee segments.
Fascia splices and corner clips are provided
to cover the gaps. Step 5:
Install Edge
Trim