Vararam VR-SDR GTO/Holden - Manual (Page 5)

CUTTING THE SHROUD
Locate release clips approximately 1/4 the of the way down the “BACKSIDE” of the shroud (one on
each side)
Tab release
As shown after cut.
Top of radiator
Mark a “HORIZONTAL” line across the backside of the shroud 3/4 inch “BELOW” the top of the radia-
tor line. This removes the small tabs that stick out at the back in one cut.
Next Release shroud from tabs and lift approximately 2-3 inches to allow for a safe cut. You can place a
piece of wood or something under the shrouds upper cover to hold it up and away from the radiator. We
used a short 2x4 but anything will do.
(You may want to place a towel in the engine compartment to keep it clean during the cutting process)
Using your cutoff wheel cut across the shroud. Once completed slide shroud back down into lock tabs,
your cut line should be 3/4 inches below the top of the radiator.