Vararam Tri-Power - Manual (Page 3)

Using your cutters remove flaps as shown, they are connected by plastic push clips in 3 locations
SUV’s usually have the soft fabric ex Avalanche, Escalade, Denali etc… Simply reach in and pull on the fabric, pop these
loose, they are connected at the top in two locations and one location on the bottom. Wear gloves or pad the area so you don’t
hurt your hands here, lots of sharp corners. (You may also use cutters to cut these out)
Once step one is completed feel underneath the radiator core support as shown. You will find a 10mm bolt on each side.
Loosen this about 1/8 - 1/4 of an inch. ( this will be used for slotted bracket placement for mounting the front scoops)
Remove VR kit from shipping box, the filter is already loaded and oiled, ready for use. We even pre crushed the hoses for you.
Tech note – there is a left and right duct, drivers side has perm nut hole on the right side as shown