Barco R9001070 - Manual (Page 98)

Service Mode
5975696 BARCODATA 2100 140798 12-5
Service Mode
5975696 BARCODATA 2100 140798 12-5
Identification
To display the Identification sreen, push the control disk up or down to highlight
Identification and press ENTER to display the Identification screen.
The Identification screen gives an overview of :
- type of projector
- projector address
- soft version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
- type of projector : BARCODATA 2100
- software version
- Proj. Address : to change the address of the projector, see Change Projector Address
in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in chapter Installation Set
Up.
Select with ê or é
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
PRESET INPUT BALANCE
MORE ...
Identification
To display the Identification sreen, push the control disk up or down to highlight
Identification and press ENTER to display the Identification screen.
The Identification screen gives an overview of :
- type of projector
- projector address
- soft version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
- type of projector : BARCODATA 2100
- software version
- Proj. Address : to change the address of the projector, see Change Projector Address
in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in chapter Installation Set
Up.
Select with ê or é
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
PRESET INPUT BALANCE
MORE ...