Waterpik WP-480 Installation Instructions - Manual (Page 2)

Installation of Showerpik ® Bracket
1. Remove current fixed mount showerhead or handheld showerhead
bracket from shower pipe leaving only the shower pipe. Remove any
leftover pipe tape residue. Ensure that the washer from the old shower
is not connected to the pipe. Use a thin utensil to check inside the pipe
for washer such as a pencil or screw driver.
Do not use your fingers.
2. Remove large nut from diverter
valve and remove pivot ball.
NOTE: The large nut and diverter
valve have a left handed thread and
loosen when the large nut is turned
clockwise as viewed from the
back of the diverter. (2)
3. Place large nut over shower pipe
with threaded end facing you
(narrow end toward wall). (3)
5
ShOwERPIk ® INSTallaTION INSTRUCTIONS
4a
Tighten
4B
Tighten
Tighten
4. Thread pivot ball onto shower pipe
and hand tighten clockwise to a
snug fit. (4A) Use an adjustable
wrench or pliers to tighten an
additional ¼–½ turn. (4B)
IMPORTANT: Do not over tighten.
5. Attach the diverter valve by
hand tightening the large nut
to the threaded back of the
diverter valve. (5)
NOTE: The large nut and diverter
valve have a left handed thread and
tighten when the large nut is turned
clockwise as viewed from the front
of the diverter.
3
2 loosen
Do NOT use pipe tape.