Weidmuller WAVE Analog DC Alarm - Manual (Page 4)

13
3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
3.2 Opening the unit
Disconnect the plugs. Disengage the top part of
the housing by carefully pressing the latches on
both sides (1). Pull out the top part of the hou-
sing and the electronics section until they lock
(2).
3.3 Settings
Low trip, high trip, FAILSAFE or NON FAILSAFE
are set via the DIP switch. SW1 in accordance with
the following tables. The hysteresis and the signal
threshold can be set via the potentiometer
positioned below the cover (3) at the front of the
module.
Warning! A screwdriver, correctly insulated
against the input voltage, must be
used when making fine adjustments
via the potentiometers at the front of
the module.
1
1
2
Signal threshold
Hysteresis
SW1
3