Weidmuller DC/DC CCC HF - with 3 way separation - Manual (Page 2)

10 11
1 General instructions
The WAVESERIES signal conditioner DC/DC CCC HF with 3-way
separation should only be installed by qualified staff and be pow-
ered up following professional installation.
2 Application
The WAVESERIES signal conditioner DC/DC CCC HF with 3-way
separation converts feedback-free all standardised in- and output
signals. These signal conditioners are supplied with voltage from
the controller and feed the input side through a DC/DC-condition-
er. Thereby is not only the input/output circuitry galvanically sepa-
rated but also the supply side.
3 Mounting and dismounting
Warning!! Mounting and dismounting may only be carried out
when the power supply has be disconnected. Failure
to observe will lead to considerable damage!
3.1 Mounting onto TS 35 DIN rails
(s. Fig. 1)
3.2 Pluggable electronic components for range alteration
(depending on model)
(s. Fig. 2)
1. Remove connector, (depending on model either screw-type
or tension clamp).
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
Warning!! The circuit board can only be inserted in one position.
The connectors have been coded by the manufactur-
er, ensuring that they cannot be reversed.
3.3 Pluggable cross-connections for voltage supply
(s. Fig. 3)
A maximum feed through of 2 A is possible.
If a signal conditioner is accidently rotated through 180°, the
cross-connection cannot be inserted.