Inserting a drive, Preparing a drive, Inserting one or both drives – Western Digital My Cloud EX2 User Manual User Manual
Page 140
REPLACING A DRIVE
135
WD MY CLOUD EX2 PERSONAL CLOUD STORAGE
USER MANUAL
Inserting a Drive
Important:
To avoid electrostatic discharge (ESD) problems, ground yourself by
touching metal before handling the device.
Preparing a Drive
The My Cloud EX2 comes with a bag holding the screws, tabs, and labels needed for
inserting the new drive. For WD replacement drives, you can reuse the parts attached to the
faulty drive.
Note:
A standard phillips-head screwdriver is all you need..
1. Using a screw from the bag, attach a plastic tab to the top hole in the drive’s side (on the
right if the green board is facing you).
2. Attach a screw to the corresponding hole on the other side of the drive.
3. Attach label 1 or 2 to the top of the drive. Label 1 is on the left and label 2 is on the right,
when looking down on the top of the unit. There are corresponding numbers on the
cross brace label.
Inserting One or Both Drives