Western Digital My Cloud EX2 User Manual - Manual (Page 15)

Bracket
Screw
Tab
Replacement
drive
Green board
facing in
Label
GETTING STARTED
10 WD MY CLOUD EX2 PERSONAL CLOUD STORAGE
USER MANUAL
Note: You’ll need a phillips-head screwdriver for this procedure.
Note: The power and network cables are not connected when you do this.
1. Press the indented button on the door (top) of the device and open the top.
2. Remove the bracket that will hold the drives in place.
3. Using a screw from the bag, attach a plastic tab to the top hole in the drive’s side
(on the right if the green board is facing you).
4. Insert a screw in the corresponding hole on the other side of the drive.
5. Attach labels 1 or 2 to the top of the drive. Label 1 is on the left and label 2 is on
the right, when looking down on the top of the unit. There are corresponding
numbers on the cross brace label.
6. When looking down on the top of the unit with the front panel towards you, and
with the connectors at the bottom of the drive facing in, gently slip the drive into
a slot.
7. Make sure the tab is sticking up at the back of the unit.