Auto-rebuilding your raid – Western Digital My Cloud EX2 User Manual User Manual
Page 91
MANAGING STORAGE ON WD MY CLOUD EX2
86
WD MY CLOUD EX4 PERSONAL CLOUD STORAGE
USER MANUAL
8.
Using the Volume slider, select the amount of space you’d like to dedicate to the
selected RAID mode.
If you choose not to use the entire volume for your RAID selection, you can configure
the remaining disk space as Spanning by selecting the Configure the remaining
disk space as Spanning check box.
9.
Click Next.
10. Review the summary of your selections, and then click Next.
11. Review the warning screen, and then click Finish.
12. The requested hard drive changes begin. Do not turn off your WD My Cloud EX2
device while these changes are in progress.
13. When the process is complete, click Finish again.
Auto-Rebuilding your RAID
The Auto-Rebuilding option allows you to automatically rebuild the RAID for your
WD My Cloud EX2 device in case of drive corruption. Use the following steps to enable the
auto-rebuild option.
1.
On the navigation bar, click Storage to display the Storage screen.
2.
Click RAID, if not already selected.