Western Digital My Book for Mac User Manual - Manual (Page 10)

MY BOOK FOR MAC
USER MANUAL
ABOUT YOUR WD DRIVE – 5
Power Button
Use the power button to safely power down the drive and avoid data loss or damage to
the drive. The power button only works when the WD SmartWare software is installed on
your computer.
Note: If you disconnect the drive after using the power button to turn it off, when
you reconnect it to your running computer, the drive automatically powers
on. If you leave the drive connected to your computer after using the
power button to turn it off, you must press the power button again to turn
it back on.
USB 2.0 Interface
The Hi-Speed USB 2.0 supports data transfer rates up to 480 Mb/s. USB 2.0 is
backward-compatible with USB 1.1. Connection to a USB 1.1 port transfers data at USB
1.1 speed (up to 12 Mb/s).
Kensington
®
Security Slot
For drive security, the Kensington security slot accepts a standard Kensington security
cable (sold separately). For more information about the Kensington security slot and
available products, visit
www.kensington.com .
Registering the Drive
Always register your My Book for Mac drive to get the latest updates and special offers. You
can easily register your drive using WD SmartWare software, as described in
“Registering the Drive” on page 36. Another way is to register online at
http://
register.wdc.com .
Handling Precautions
WD products are precision instruments and must be handled with care during unpacking
and installation. Drives can be damaged by rough handling, shock, or vibration. Observe
the following precautions when unpacking and installing your external storage product:
• Do not drop or jolt the drive.
• Do not move the drive during activity.
• Do not use this product as a portable drive.
• To allow proper ventilation, do not block any of the enclosure’s air slots.