Western Digital My Book for Mac User Manual - Manual (Page 64)

MY BOOK FOR MAC
USER MANUAL
INSTALLING THE SES DRIVER – 59
Installing the SES Driver
If you do not install the WD SmartWare software, installing the SES driver on Windows
computers keeps the hardware popup wizard from displaying every time you connect
your My Book drive to the computer.
Note: The SES driver is installed automatically when you install the
WD SmartWare software or if you clicked Do Not Install on the
Welcome to WD SmartWare screen (see “Getting Started Without
the WD SmartWare Software” on page 56)
.
This appendix includes the following topics:
Installing on Windows XP Computers
Installing on Windows Vista Computers
Installing on Windows 7 Computers
Installing on Windows XP Computers
After connecting the drive as shown in Figure 4 on page 6, the Found New Hardware
Wizard screen displays.
Note: If Autoplay is enabled, two additional screens might appear at the same
time as the Found New Hardware Wizard screen. If they appear, close
them.
You can use the Found New Hardware Wizard to install the SES driver either:
• Automatically, if your computer is connected to the Internet
• Manually, whether your computer is connected to the Internet or not
Installing the Driver Automatically
To install the SES driver automatically, your computer must be connected to the Internet:
1. Verify that your computer is connected to the Internet.
2. On the Found New Hardware Wizard screen, select Yes this time only to allow
Windows XP to connect to Windows Update:
3. Click Next to continue.
1
A