Western Digital My Net Switch User Manual - Manual (Page 8)

MY NET SWITCH
USER MANUAL
INSTALLATION – 5
Installation
Step 1 - Connect to Router
Connect your router to one of the LAN/LOW Ethernet ports on the switch.
Step 2 - Connect the Power Cable
1. If applicable, connect the power clip to the power cable plug.
The AC power adapter will vary, depending on your location. Some locations do
not require a power plug clip. Units sold in those locations will have a fixed power
plug. Refer to the illustration below.
4
EU/KO EU/KO US/JA/TW US/JA/TW
Installing Installing Removing Removing