Wolo 3367P-G Bright Star - Manual

Y our purchase of a Wolo warning light is the perfect choice to compliment your vehicle. Our warning lights
are manufactured with the finest of materials and each light is tested before it is packaged.Quality
workmanship and components are Wolo’s assurance of a product that will provide years of dependable
service.
Before installation of this warning light is attempted, it is important to read these instructions completely. The
lives of people are dependent on proper installation. The person installing this light must have advanced
knowledge of the proper method of installing warning lights to a vehicle, as well as, knowledge of the
vehicle's electrical system. Again, read this manual completely and note any messages marked
‘‘IMPORTANT” or ‘‘WARNING”. A safe installation will prevent serious injury and/or damage to the vehicle.
IMPORTANT: Installation of this warning light may require drilling to the vehicle. The installer must carefully
inspect both sides of any location that will be drilled to ensure that there are no components, wires and/or any
vehicle parts that could be damaged when drilling.
IMPORTANT: Always de-burr any drilled holes to ensure that there are no sharp edges. Install the plastic
grommet into the hole that the wires are being routed through. Always refer to the vehicle’s shop manual for
the deployment location of the air bags. Never install the on/off switch, wires and/or components in the
deployment area of any air bag. Improper installation could reduce the effectiveness of the vehicle's air bag
system and/or project an object that could cause serious personal injury or death to the driver or passenger.
The user/installer assumes all responsibility to properly assess a
safe mounting location for the switch to ensure ultimate safety to
the driver and passengers inside the vehicle.
WARNING: This warning light contains a high intensity strobe
bulb. To prevent permanent eye damage, DO NOT stare into the
light beam at close range.
MOUNTING WITH SCREWS (FIG. A & B)
1. Select the location you wish to mount the warning light. For
best results, the installer should make sure the lens is
unobstructed so that the light can be seen at 360 degrees.
2. Using the holes in the warning light’s base, mark the three (3)
hole locations for mounting the light. Remove the warning light
from the mounting location and drill holes using a 3/16” drill bit.
NOTE: There are two methods to route the warning light’s wires:
2A. Route the wires through the notch in the base of the light.
2B. Route the wires through a hole directly under the base of the
warning light.
3. If needed, drill a hole for the wires, using a 5/16” drill bit. De-burr
the drilled hole and insert the provided plastic grommet into the
hole. The plastic grommet will ensure that there are no sharp
edges around the hole that could damage the wires. IMPORTANT:
If waterproofing is required, use silicone sealant around wires and
plastic grommet.
4. Secure the base of the warning light to the vehicle using only the
hardware provided. To prevent vibration and water leaks, use the
metal ring and gasket provided. Position the ring and gasket so the
holes in the ring align with the base and the rubber gasket.
INSTALLATION INSTRUCTIONS FOR
BRIGHT STAR STROBE WARNING LIGHT
Permanent Mount Model 3350P-A, 3355P-B,
3360P-R, 3365P-C & 33 P-G
FIG. A
FIG. B
67