Wolo 3780-R Outer Limits - Manual

INSTALLATION INSTRUCTIONS FOR
MODEL 3770M-A, 3775M-B & 3780-R OUTER LIMITS
LED WARNING LIGHT MAGNET MOUNT
Your choice of a Wolo warning light is the perfect choice to compliment your vehicle. Wolo’s warning lights are
manufactured with the finest materials. Each light is tested to meet our high standards before it is packaged, to
assure a perfect working light. Our quality workmanship and components are Wolo’s assurance of a product that
will give years of dependable service. If you need help using your new Wolo warning light, our technicians are
available to answer your questions, Monday thru Friday, from 9 AM to 4 PM EST at 1-888-550-4676.
MAGNET MOUNTING IMPORTANT: Vehicle roof construction varies for model vehicle as well as driving
conditions. The vehicle should never be driven with this warning light magnetically mounted. It is possible that the
light could dislodge off the mounting surface and cause damage, injury or death. Ignoring this warning shall be the
sole responsibility of the user and or vehicle owner.
IMPORTANT: The magnets’ holding power to the mounting surface is dependent upon the following: flatness,
thickness, condition and finish of the mounting surface, as well as the distance between magnets. For maximum
magnet strength, follow these recommendations:
1. The vehicle’s mounting surface should be kept clean and free of wax, dirt, dust and foreign particles.
2. The bottom of the magnets’ rubber cover should be kept clean and free of wax, dirt, dust and foreign particles.
3. Always make sure that the mounting surface is flat and that all four (4) magnets are fully secured.
4. Never attempt to secure the magnets to a vehicle that has a fabric or vinyl covering the mounting surface.
5. Once you have located the desired mounting location, you should make sure the lens is unobstructed so that
the light can be seen 360 degrees.
ADJUSTING MAGNETS POSITION:
6. Each of the four magnets can be positioned to best fit the mounting surface. IMPORTANT: The light bar will
have maximum holding power when the magnets are separated furthest from each other.
7. Turn the magnet one to two turns counter-clockwise.
8. The magnet will freely slide in its in its track. Select the desired position for the magnet and tighten by turning
the magnet clockwise.
9. Repeat above procedure for any magnets that require repositioning.
MOUNTING SWITCH CONTROL PANEL Fig. 1:
10. Select a mounting location for the switch control panel on either the dashboard or console. IMPORTANT:
Always carefully inspect mounting location to ensure that it will not interfere with air bags, vehicle’s operation
or driver’s vision.
11. Before mounting the switch control panel make sure the light’s cigarette
plug will easily reach the vehicle’s power outlet.
12. Using the double-sided foam adhesive tape provided, mount the switch
control panel to selected location. Make sure that mounting surface is
free from dust, wax etc. A clean surface is necessary so that tape will
hold properly. IMPORTANT: THE TAPE’S ADHESIVE HOLDING
POWER BECOMES MAXIMUM IN ABOUT 24 HOURS. LIMIT MOVING
OR PUTTING PRESSURE ONTO THE CONTROL PANEL UNTIL THEN.
Fig. 1