Wolo 7900 SERIES Lookout - Manual

LOOKOUT
™
LED LIGHT BAR
INSTALLATION MANUAL
7900 SERIES
Your purchase of a Wolo warning light is the perfect choice to compliment your vehicle. Wolo’s warning lights
are manufactured with the finest materials. Before being packaged, each light is tested to meet our high
standards and ensure a perfect working light. Our quality workmanship and components are Wolo’s
assurance that this product will provide years of dependable service. If you need help using your new Wolo
warning lights, our technicians are available to answer your questions, Monday thru Friday, from 9 AM to
4 PM EST at 888-550-4676.
Before installation of the light bar is attempted, it is important to read these instructions completely. The lives of
people are dependent on a proper installation of the light bar to the vehicle. The person installing this light bar
must have advanced knowledge of the proper method for mounting and securing the light bar to a vehicle's roof
or exterior, as well as knowledge of the vehicle's electrical system. Again, read this manual completely and note
any messages marked “IMPORTANT” or “WARNING’’. A safe installation will prevent serious injury or damage
to the vehicle.
LOOKOUT comes completely wired and does not require any internal wiring by the installer. The power
cable has all the required wires with factory installed terminals and connectors for a successful
installation.
Installation of the LOOKOUT Light Bar requires drilling into the vehicle. The installer must carefully
inspect both sides of the selected locations to ensure that there are no components, wires and/or any
other vehicle part that could be damaged by drilling. IMPORTANT: Always de-burr any drilled holes,
ensuring that there are no sharp edges. Install a rubber grommet into all metal holes that the wires are
being routed through.
Always refer to the vehicle’s shop manual for deployment location of air bags. Never install the light bar's
switch control panel, wires and or components in the deployment area of any air bag. Improper
installation could reduce the effectiveness of the vehicle's air bag system and or project an object that
could cause serious personal injury or death to driver and passenger. The user/installer assumes all
responsibility to properly access a safe mounting location of the light bar's control panel, to provide
ultimate safety to the driver and passengers inside the vehicle.
The vehicle operator and or maintenance department should inspect the light bar frequently to ensure all
brackets are securely attached to the vehicle and that all mounting hardware is free of corrosion.
The light bar’s control panel should be mounted in a location where the switches can be easily reached.
Never attempt to turn light bar on/off when driving under hazardous conditions.
These installation instructions should always be kept and stored in a safe location so that they can be
referred to when information, maintenance or reinstallation is required.
Failure to follow all safety precautions and installation procedures outlined in these instructions could
result in property damage to the vehicle, serious injury or death to you or others.
MOUNTING LIGHT BAR
1. Place the light bar on the selected location of the vehicle's roof. A preferred mounting position on the
roof is close to the B-pillar, which is the strongest part of the roof. IMPORTANT: Make sure the light
bar is facing the correct direction. NOTE: there is a label on the light’s front lens indicating the take
down lights.