WORX WU706 115mm 710W Angle Grinder 240V - Manual (Page 12)

12
gRINDINg/CUTTINg DISC
Pay attention to the dimensions of the grinding disc. The
mounting hole diameter must fit the inner flange (6) without
play. Do not use reducers or adapters.
When using a diamond cutting disc, take care that the direction-
of-rotation arrow on the diamond cutting disc and the direction of
rotation of the machine (direction-of-rotation arrow on the machine
head) agree.
For mounting, see the Component list illustration page.
Screw on the outer flange (5) and tighten with the two-pin spanner
(9). (See Fig. B)
ADJUSTABLE OUTER FLANgE CLAMPINg
The outer flange (5) should be adjusted to suit different disc
thickness. For thinner cutting or diamond discs the raised part of the
outer flange is fitted facing away from the disc (See Fig. C.2). For
thicker grinding discs the raised part of the outer flange is fitted facing
towards the disc to provide improved support for the disc hole
(See Fig. C.1). Always ensure your disc is securely clamped.
ADJUSTINg THE PROTECTION gUARD
Before any work on the machine itself, pull the mains plug.
For work with grinding or cutting discs, the protection guard
must be mounted.
The coded projection (12) on the protection guard (10/13) ensures
that only a guard that fits the machine type can be mounted.
Loosen the clamping screw (11), if necessary.
Place the protection guard (10/13) with coded projection (12) into the
coded groove on the spindle collar of the machine head and rotate to
the required position (working position).
2
3
B
C1
C2