WORX WU706 115mm 710W Angle Grinder 240V - Manual (Page 13)

13
The closed side of the protection guard (10/13) must always
point to the operator.
Tighten clamping screw (11).
Operation
STARTINg OPERATION
To start the power tool, push the on/off switch (1) forward.
To lock the on/off switch (1), press the on/off switch (1) down at the
front until it engages.
To switch off the power tool, release the on/off switch (1) or, if it is
locked, briefly push down the back of the on/off switch (1) and then
release it. (See Fig. D)
OPERATINg INSTRUCTIONS
Clamp the workpiece if it does not remain stationary due to its own
weight.
Do not strain the machine so heavily that it comes to a standstill.
Grinding and cutting discs become very hot while working; do not
touch until they have cooled.
Pull the plug from the socket-outlet when not using the machine.
With the plug inserted and mains voltage existing, the power tool still
has low power consumption even when it switched off.
HAND gRIP AREAS
Always hold your angle grinder firmly with both hands when
operating (See Fig. E). 1
D
1
•
•
•
•
E
F