Yamato Scientific DVS602 Constant Temperature Drying Oven - Manual (Page 20)

18
4. Operating procedures
Operating procedures (quick auto stop operation)
Procedures for quick
auto stop operation Used when you want to, for example, “stop fixed temperature
operation being performed automatically in several hours. Quick auto
stop operation is a function to enable auto stop timer setting during
operation.
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
1. Setting time period before stop during fixed temperature
operation
Make sure that the FIXED TEMP. lamp is illuminated to indicate the
unit is the fixed temperature operation mode.
Press the TIMER key.
The character tim that indicates the timer is displayed on
the MEASURED TEMP. display and the current set time flashes on
the SET TEMP. display.
Set a time you want using the ▼▲ keys.
About the timer function The maximum time that can be set for the timer is 999 hours 50
minutes.
Up to 99 hours 59 minutes, time can be set in minutes.
One hundred hours and over are set only in 10 minutes.
Keep the ▼▲ keys pressed to continuously change set time and you
can quickly reach the time you want. Press the ▼▲ keys once at a
time for fine adjustment.
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
2. Starting timer operation
When you have set a time you want, start the RUN/STOP key for
about one second. Timer operation starts with the FIXED TEMP.
lamp and the AUTO STOP lamp are illuminated. Timer starts
counting when the RUN/STOP key is pressed.
3. Stopping and ending timer operation
Operation stops automatically when the set time comes.
The buzzer sounds for about five seconds to indicate operation has
stopped. At this time, the character End that indicates
operation end is displayed on the SET TEMP. display with the
FIXED TEMP. lamp and the AUTO STOP lamp are illuminated.
Press the RUN/STOP key for approx. one second to end the timer
operation mode. The screen switches to the initial setting screen.
When you want to
correct set
temperature or set
time, or confirm
settings When you want to change set temperature during operation, press the
FIXED TEMP. key to enter the setting mode and change the set
temperature. After change has been made, press the ENTER key to
complete the process. When you want to change set time during
operation, press the TIMER key to enter the setting mode and change
the set time. Note, however, you need to set a time calculated by
adding the time already passed to the time to be added. After
change has been made, press the RUN/STOP key to complete the
process.
Pressing the ▼ key will display the set temperature, the operation
mode and the remaining time on the SET TEMP. display.