Yamato Scientific DVS602 Constant Temperature Drying Oven - Manual (Page 21)

19
4. Operating procedures
Operating procedures (auto stop operation)
Procedures for auto
stop operation Used when you want to “set automatic stop after set time has elapsed
from the start of the fixed temperature operation.”
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
1. Setting a stop time
① Press the TIMER key in the initial screen.
② The timer mode you used in the previous session is displayed on
the SET TEMP. display.
Pressing the TIMER key again to flash the timer mode.
Pressing the TIMER key again to flash the next timer mode.
Select the character AStP that indicates the auto stop
operation and press the ENTER key.
The character Sv that indicate a set temperature is
displayed on the MEASURED TEMP. display on which the
current set temperature flashes and the AUTO STOP lamp
flashes.
③ Set a temperature you want using the ▼▲ keys.
④ Press the ENTER key. The character tim that indicates
the timer is displayed on the MEASURED TEMP. display and the
current set time flashes on the SET TEMP. display.
⑤ Set a time you want using the ▼▲ keys.
About the timer
function
The maximum time that can be set for the timer is 999 hours 50
minutes.
Up to 99 hours 59 minutes, time can be set in minutes.
One hundred hours and over are set only in 10 minutes.
Keep the ▼▲ keys pressed to continuously change set time and you
can quickly reach the time you want. Press the ▼▲ keys once at a
time for fine adjustment.
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
2. Starting timer operation
When you have set a time you want, start the RUN/STOP key for
about one second.
Timer operation starts with the AUTO STOP lamp is illuminated.
Timer starts counting when the temperature in the bath (measured
temperature) reaches the set temperature.