Yamato Scientific RE540 Evaporators, Rotary - Manual (Page 13)

10
Installation/Assembly
4. Set the cooling condenser nut, coil ring and vacuum seal to the condenser or
condenser connector.
1. Remove the cooling condenser nut and coil ring on the left side of motor.
2. Connect the cooling condenser nut and then the coil ring to the condenser or condenser
connector (which ever applies). Be sure to put the nut on first.
3.Insert the vacuum seal to the condenser or condenser connector (which ever applies).
※ It is optional to put grease on the vacuum seal.
● Insert the convex side of the vacuum
seal into the flange of cooling
condenser or condenser connector.
5. Connect cooling condenser or cooling condenser connector to the motor.
Insert the steam duct into vacuum seal, put glass flange to the motor and fasten firmly the cooling
condenser nut.
＊ ＊ ＊ ＊ Be careful not to damage the set vacuum seal when you put steam duct into the flange
with the seal in case the damage could cause leak.
Glass Type A Glass Type B/C
Above : Fitting of Coil Ring and Vacuum Seal
Below : Fitting to Motor
Above : Fitting of Coil Ring and Vacuum Seal
Below : Fitting to Motor
● ● ● ●When you remove the coil ring from cooling condenser or condenser connector
Hook the coil ring by the attached hexagon wrench as shown in the left
picture in order to remove the ring easily from the cooling condenser or
connecting condenser. However, be careful not to force too hard in case
the glass apparatus or the coil ring might be damaged.
Coil Ring
Vacuum Seal
Coil Ring
Vacuum Seal
Vacuum Seal
Cooling Condenser Nut
Coil Ring