Yamato Scientific RE540 Evaporators, Rotary - Manual (Page 14)

11
Installation/Assembly
6. Connecting the cooling condenser holder shaft. (glass set B & C only)
Fit the cooling condenser holder shaft firmly into the screw hole on the back of motor. Put the
attached hexagon wrench through the hole on the end of shaft and fasten tightly.
7. Connecting the cooling condenser and condenser holder (B & C
condensers only)
1. Connect the cooling condenser to the condenser connector and hold by the cooling condenser
clamp.
2. Insert the cooling condenser holder from the top of condenser, while fitting the other side
through the holder shaft. (For type C, be sure to insert the cooing condenser holder from the
bottom of condenser rather than top and then connect the condenser to the condenser
connector)
3. Fit the suction cock for type B or the cooling condenser lid for type C.
Cooling Condenser Clamp
Cooling Condenser Holder
Suction Cock
Condenser Lid